Timber Wolf Bandsaw Blade 1/2" X 93-1/2", 4 Tpi

I seldom write reviews because I expect things to just work. But this blade is the best band saw blade I have ever used in 40 years. It came with a detailed instruction on how to properly adjust the tension on the blade. I did as it stated and this blade cuts like cutting butter. Very quiet, tracks true and extremely sharp. I was cutting walnut and maple, no issues at all. There is no comparison between this blade and any blade I have ever purchased at a box store. I highly recommend it.

My husband was so pleased with how sharp these blades were. It was a great value for the price.

Works so well I bought another one for a spare!

I am not in the habit of writing reviews but I am so impressed with this bandsaw blade that a review is in order. I have an older Delta 14 inch bandsaw and recently purchased a couple of Timberwolf blades after having poor success while resawing walnut for a small project. After mounting the blade (1/2"), tensioning according to Timberwolf's written instructions, resetting blocks and bearings, and lubricating the blade with Pam (again, Timberwolf instructions), I now have a machine that runs better than it ever has. It is also operating so quietly I am tempted not to wear any hearing protection. To test operation I successfully resawed 1/8" slices off of 3" hard maple. The results are perfecting straight and very smooth. I highly recommend Timberwolf blades and suggest following the tensioning and lubrication instructions included with their blades.

New bandsaw owner (used Jet 14”) and after reading online about the highest quality blades I decided to go ahead and spend the extra money on the Timber Wolf. I had alread upgraded my saw with the Rockler 10 bearing guide kit but the blade that came with the saw still wandered all over the place and took way too much pressure to cut even soft wood. It felt sharp to me but I knew it needed replacing. Well once I installed and tuned the new 1/2” Timber Wolf blade, I marked a straight square line across scrap wood and cut it using the miter gauge. It tracked the line perfectly and went through it like I was cutting air. Spend the extra cash, you won’t be disappointed. I did not give a stat on longevity as I haven’t had it very long but will come back and revise this review once I’ve put some use into it.

I have recently been using my 14" bandsaw to resaw hardwood for jewelry box building. This has required tuning the saw and building some fences to support the resawing Years ago I bought several widths of Rigid brand blades when they were marked down on clearance. After getting the saw tuned and some good fences built I managed to cut boards in half but the cut quality was so poor extensive planing was required. The reviews of Timberwolf on the Internet are all over the place but the majority are favorable so with Prime same day delivery I bought this Saturday morning and had it in hand by the late afternoon. I was aware this blade is low tension and I followed the instructions when I installed it. I made a test cut on a piece of ash and I am pleased. The quality of the cut is not perfect but it is very good and it may get better as I become more accustomed to pushing the board through without any stops. I will still run it through the planer but it will only take one light pass to clean it up. The blade runs quiet. Right now I think this is a winner, but I will also admit I ordered a 1/2" Wood Slicer blade from Highland just in case this one did not cut smoothly. I like this one well enough that had I waited until I could try it out I would not have ordered the Wood Slicer blade.

I have a delta 14” bandsaw, it was always a bit wonky to cut with now matter how much I changed the guides, once I switched to this blade wander went bye bye, the saw behaves completely differently. Prior to this blade my saw was a waste of money, now its worth every penny.

Nice blade. After dialing my old Delta bandsaw dialed in, it has never worked better.