DiamondX50A X50 X50-A Diamond Original 144/440 MHz Dual Band Base Antenna - UHF Connector, 5.6 FT

This antenna is a replacement for the one that I had previously that took a lighting strike. Works really well for me at a height of 65' on top of my tower. I have had no issues with the construction nor operation.

I purchased this antenna based on a recommendation from a friend and the overwhelmingly positive reviews on eHam. I'm very glad that I did. While I haven't connected it to a standalone analyzer yet, my radio is reporting a 1:1 SWR across the 70cm band and the majority of the 2m band, with a maximum SWR of 1.5:1 at the top of 2 meters.No antenna is magical, and there are so many variables that influence range. That said, I'm operating indoors in an area full of interference (a Chicago apartment with no balcony—far from ideal), and able to work UHF simplex at 35W with folks 30-40 miles away. The antenna is mounted to a section of PVC pipe, slipped over the neck of an inexpensive tripod with the camera mount sawed off. The connection to my transceiver is made via 50' of LMR-400 to a Daiwa cavity switch, with another 7' of RG-213 running to the X50A. The antenna's mast mount features a very cool design that protects the coax interface from water ingress. If only I could stick the thing outdoors.

I bought this antenna to replace one I got via trade and though it was broken internally. Turns out it was bad coax! This antenna works very well for all repeaters in my area. Easily gets me into all in a perhaps 45 Mile radius. I have it mounted on my roofline. Severe weather has caused no issues. I am very pleased. Performance is good, it seems very rugged, matches well for swr. Price is not cheap, but it is high quality in my opinion.

I use this with a Yaesu HT, and it works really well. My antenna mount is far less than ideal, and the performance is quite acceptable. The antenna is small enough that you could put it in the car for use at a remote site.I only gave 4 stars, because the mounting bracket does not match the other half for a pole mount. Not the end of the world. I used half the bracket and just screwed it to a pole. I had been through some serious wind, snow and rain, and is holding up very well.Without question, I would buy this antenna again.

Very nice antenna. It is light weight and easy to install. I connected it to an existing TV antenna mast with a 5' pole which gave me a total height of 35' at the base. I use it with a Baofeng HP-82HP and a scanner. I am able to connect with 2 meter repeaters at quite a distance. I can hear police and state patrol units at over 50 miles away even though the antenna isn't tuned for those particular frequencies. This antenna could be used as a portable unit while camping or at events. I wouldn't recommend it to be permanently mounted on a vehicle because of the wind resistance.

The media could not be loaded. The antenna is actually shorter than expected. The size measured 5.6' is with the mast mount included.But works great.

I was having issues with this antenna since the beginning, thought it was my equipment but finally got a vSWR and it tests horribly (almost a flat 16.523 on all frequencies). All my other antennas test just fine. Will need to send to Diamond for warranty.

This is simply just a great antenna. I'm new to Ham radio and this is the antenna I was told so much about. I use it with an affordable mobile radio and I sound great coming through the local repeater. when I tell people what antenna I use they always say "that's a good antenna" or "sounds great!". You cannot go wrong with the diamond X50!