EZ-Fluid 1/2" FIP Female Iron Pipe X 3/8"Comp X 3/8"Comp 1/4 Turn Double Handles Dual Outlet LF Brass Angle Stop Valve Water Shut Off Ball Valve For Water Pipes,Faucet,Toilet Valve,Icemaker,Filter(1)

I should have taken a picture of what was done prior from the old owner of my house. These are great to clean it all up. Both hot and cold had 1 “T”, 2, 1” nipples, 1, 90 and 2 gate valves with 2 fittings to the 3/8 compression fittings? WTF? What a mess it was! Now it’s clean!

Great product for under a kitchen sink. The cabinet area under a sink can become cluttered with hoses, electric cords and disposers. This value is low profile and allows for a neat and orderly arrangement of the hoses for my faucet, dishwasher, and ice maker.

I really like this type of quarter-turn shutoff valve which is commonly available for a single shutoff. This valve is the best when wanting a separate hot water shutoff for the kitchen faucet and the dishwasher.

I needed another 3/8" comp outlet for a dishwasher, and replacing the single-outlet valve with this dual-outlet valve was the simple solution. I removed the old valve and cleaned the threads on the pipe from the wall, and then wrapped the threads with a quality PTFE tape and installed the new valve. Some reviewers noted the lack of flats for a wrench on the valve body (where it attaches to the outlet pipe from the wall). My solution was to remove the compression sleeve from one 3/8" valve outlet, and then re-install and fully seat the compression nut. Rotate that valve handle to its "closed" position to get it out of the way. Next, use a large enough adjustable wrench to seat against the top of the nut and rear of the respective valve. You'll be able to turn the valve easily rather than relying trying to grip the round valve body. It's a solid well made valve, and the quarter turn valves showed no signs of leaking.

Installed easily, shutoff valves work easily and do not leak. Note that there are no flats for a wrench. I used a rag to protect the chrome from the jaws of my pliers when installing. It's nice to have separate valves for the two water outlets -- some have a single valve with two outlets. If something goes wrong with the dishwasher (inlet valve or the like), I can shut it off without also losing hot water to the sink.

Well made with one minor flaw. There is no hex or flats on the pipe fitting side. This leaves you to have to use pliers to tighten it fully which will mar the surface even if you are careful. Other than that, it’s a good valve set.

Plumbing repair

Excellent. Built very good.

Je n’ai reçu qu’une valve sur le lot de 5