Creality Ender-3 Upgraded Open Source 3D Printer Easy to Assemble DIY Kit, Standard

Printer is good but have some flaws.ABS filament : Description says that it allows printing with ABS, but practically it doesn't. I tried many times, but it doesn't.Bed alignment : I don't know why, but this printer requires bed alignment every time. Its frustrating.Black plate : black plate which we place on bed is not flat. Its bit curved in center. Bed alignment is done at bed corners, so when printing starts, nozzles rubs with black plate in center. might damage nozzle.Assembly : Assembly is difficult. Manual is not that helpful. Being an engineer, it was difficult for me then I can assume, how much it will be difficult for non technical person.Build quality : built quality is good. feels strong.Overall : Not highly satisfied as I specifically bought as it mentioned that it prints ABS. Bit disappointed.

Bought it during a sale at very competitive price. It's a semi assembled kit. Instruction manual is not clear for novice in mechanics. But, many YouTube videos are available for assembly. Semi assembled kit is a good idea to teach all parts of a 3d printing. Well packed. Additional spares provided (extra screws, nozzle, etc).Package was shipped from maharashtra, found some water damage on box (might have been due to recent floods). But, i did not see any water seeped inside box.

The manual didn't help for complete installation. We had to take help of a technical person

The assembly ideally should take abot 90-120 minutes, the print bed adjustment did take a little longer, the best approach is to completely tighten the adjustment knobs, start with left front, open the knob until 1 mm from the bed, next right front, right rear and finally left rear, repeat in the same order, this time placing a 1" wide x 2" long paper between the bed and the nozzle, adjusting the knobs until the paper can move between the bed and nozzel with some resistance.First try printing using PLA, hapy 3D printing...

This is my second printer and while assembling i found out that there is wobling on my y axis. While printing the bed is moving slightly and my first layer is effecting because of it. And also miising twizerss in the box. Otherwise the product is good and is of low prize.

Its a pretty good printer for such an affordable price. Print quality is fantastic. The manual to setup was a bit hard to read. Had to watch YouTube videos to assemble. Otherwise an awesome product.

Needs effort to setup and install, but the results are rewarding. Look up YouTube for installation instructions.Print quality is decent. No fussy re-branding stickers. Superb packaging!

Easy to assemble! Pocket friendly 3D printer to realise your dream design. Delivered at your door step. Thank you WOL3D & Amazon.