KitKing - SPX1600TRA Super Pump Seal Replacement for Hayward Go Kit 3. Fits SP1600, SP2600 in Regular, X, VSP Models. SPX1600TRA SP1600Z2 PS-201 SPX1600R SPX1600S SPX1600T Pool

Perfect fit. Had a leak between the pump housing and the skimmer housing. Can only be one of 1 of 4 items and this kit had all 4 plus the skimmer gasket. I found a video on line with step by step instructions and I had it done in about 15 to 20 minutes. Only piece of advice is when you access the rear of the motor to keep the rotor / impeller from rotating so as to unscrew it, there is a little trick using a 7/16" open-end wrench, you need to loosen the capacitor so be careful not to touch the wires as it will shock you even with the power off so insulate with a rag so you don't make contact and it does not make contact with anything metal.

It's a good kit, everything fit well.

This fit my pump and repaired the leak that was shorting out the pump and tripping the breaker. This kit saved me from buying a new $700 pump. It was very easy to replace all the gaskets. Just buy the kit with the silicone lube, or have some silicone lube on hand to complete the setup of this gasket kit. Awesome purchase. I'm very happy I bought this and was able to fix my pump and save a lot of money.

All seals were fine EXCEPT the pump basket lid seal. Would not seal leak free no matter what I tried. It seems too thin. I put the old lid seal back on and no leak! Impeller shaft seal, and other seals fit and worked like new.

Rebuilt my Hayward pump (again)...everything fit perfectly and I had no leaks in the end so very happy with this kit.

I installed a Hayward Super Pump unit in 2017. This spring I switched to salt water and after running the pump for a couple of weeks, I noticed a small leak from the bottom of the pump. I don't know if the shaft seal started leaking because of the switch to salt or just age, but I picked up this kit to fix it. The kit comes with all of the part necessary to rebuild the pump. The first picture shows the parts included- 1 diffuser gasket, 1 cover gasket, 1 housing gasket, 1 Two Piece Shaft Seal Assembly. Removal of the old parts and installing the new ones is pretty straightforward. I won't go through all of steps because there are plenty of videos online. The only difficult part was removing the impeller. The second picture shows the old parts taken out of the respective pump part that has the new part installed. I used some silicone, food grade, grease on the o-rings so the parts would slide together easier. If you use a lubricant make sure none of it gets on the two piece seal assembly. If you do, it will leak and you'll have replace it. (I learned this the hard way.) The last picture shows the amount of salt and corrosion from a small leak that was only 3 weeks old. The pump is back together and running without any leaks so the kit works perfectly.

Lid seal oversize. Had to reuse old seal.

Fixed my problem right up. Happy to be able to replace $15 worth of parts to fix a problem that otherwise could have cost $500-$800 without labor (which is always me anyway). My old seals didn't make it through the winter. I bet a ton of water went into the ground around my pump. Replaced with these and problem gone.

No me gusto, que la goma de la bomba es más grande y no le queda. No es de la medida.

Fitted perfectly! Saved our filter.

Good replacement kit for my 15 years old pool pump. Stopped the leakings.

Exactly as described, quality materials and easy to install.

All parts fit as they should have