5" Round Access Hatch Cover Deck Plate for RV Marine Boat

This is a really nice hatch. I installed it on my Travel Trailer propane tank cover so that it was easier the see the propane level gauge and to reach the switch tank lever. Is screws on and off without any binding and stays tight without more than finger tightening. I do recommend this hatch.

Perfect fit for Perception Outlaw 11.5.Great product and was easy to install. I used rivets and sealant and it only took a few minutes per hatch. These are preferred over the Harmony 5" hatch which is three times the cost. These look better IMO as well because they are black and not grey.If you are looking for hatches for your Outlaw 11.5, do not hesitate to buy these.

I used this to make a way to my RV sewer hose out the bottom of the compartment instead of having to leave the compartment door open with the hose attached. It works great. Now I can open this hatch, put the sewer hose up into the compartment and attach it, then close the compartment door. Much better.

Fits perfect, didn't come with hardware.

I've been a sailor most of my life and used many of these for access to pplaces you can't see. This one looks good and has a seal on screwin cover will even stop air, I'm using it on a plenum on my furnace duct for inspection purposes

Used this to replace the 4.5" deck plate in the sewer bay of my National Dolphin class A motor home. The old plate was slightly too small for the Rhino Flex sewer hose couplings to fit through and I decided it was cheaper to replace the plate rather than buy a different brand of hose. I used a 5" hole saw to enlarge the existing hole, but it really needs a 5-1/4 inch cutout as I had to enlarge the hole further with a sanding drum on a drill to get this plate to fit properly. Once I did that everything fit fine and I no longer have to leave the bay door open to run the sewer hose out. This plate seems to be of good quality, but it does not come with mounting screws.

Really only needed the lid but glad I had both pieces to replace

I added 2 of the these to my Perception Outlaw. Fit nicely. I used a 5 1/2” hole saw & installed with stainless screws & marine sealer. They turned out great & reasonably priced.