Autel TPMS Sensors Set of 4, Tire Pressure Sensor MX-Sensor 315+433MHz

Great sensors. Good quality and good compatibility. Easy to program with any autel TPMs tool to adapt to your car and even clone to your old sensors. Long lasting and they don’t look cheap like some oem TPMs sensors. They just look like normal valve stems

was hesitant to purchase this sensor cause I bought OEM ones and didn't last, had a good friend that bought this and it been 8 months and still working great and a lot less expensive

With Autel being a name i trust I am happy with this product. Tire shop programmed without any problems high quality easy to install recommended to anyone.

Works as should. OEM functionality and MUCH cheaper than OEM; so much better value. Especially if you have two sets of wheels/tires with summer/winter sets. Buyer beware, however. If the shop you take it to does not have the right tools for a 23 WRX, like mine, have them program it to a 21 Forester of their tool doesn’t go up to 2023. Both cars operate under 433mhz. The tire shop I went to originally programmed it to a 21 WRX, since the tool only went up to 2021. The 21 WRX operates at 315mhz and so the sensors will be happy as they’re 2in1, but my car did not recognize it. This took a few days of working with them until I found this on Reddit.

They work Great !!!!!

Terrible product. Lasted less than 2 months before the battery was dead on all 4. Would not by again. Do not recommend. Dont waste your time or money.

Worked hard

Good - Works well

Excellent

Works as they should

Assuming you have the right tool, it's so easy to program. I have the Autel MaxiTPMS TS401. I used these sensors in a Toyota vehicle to clone my original sensors (for the winter tires set). I cloned them in less than a minute, that fast. They are working great so far.

سيئ

It works well on my 2023 4runner and i used ts508wf programming tool btw. At first, i made a mistake by installing the tpms first to my winter tires before registering ID. It will not read the sensor once you installed before registering. Luckily, before i stored my summer tire, i wrote which one is LeftFront, RF, RR, Left rear. So i did copy by activation from my summer tire and followed the steps and from there i was able to clone the ID's from my summer tires to my unregistered installed tpms on my winter tires. Once the cloning is finished, i did tpms diagnostic for all tires and insert obd2 port. Voila!! Problem solved. Lights came off.