GlowShiftGlowShift Black Quad Pillar Gauge Pod Compatible with Ford F-Series F-250 F-350 Power Stroke 1992-1997 - ABS Plastic - Mounts (4) 2-1/16" (52mm) Gauges

I haven’t even gotten far enough to see if it fits my truck, I decided to put on of my gauges in it. My gauge slides into tue pod, tightly, and the backside is so tight I can’t screw on the collar to keep the gauge secure! Gonna play a bit and see what I can figure out, but disappointed with the tight fitment

Installed on an 89 Ford F350. Fit pretty good. Had to trim some material away to fit on the stock trim piece. Used a small amount of heat to form it closer to the stock shape. I used #8 self taping screws so I could remove the pod assembly from the trim during fitment. Once fit I drilled the holes larger for permant push pins.

This pod is installed in my 1995 F350 Powerstroke. The fit is very clean if you install it properly. It is not designed to just pop into place. Simple hold it into place, mark top and bottom of you trim and remove both. Fasten to your trim with supplied hardware as well as drilling the 3 holes that hold your trim to your truck. Prefitting the pod you will have a slight bow in the middle, little pressure with your hand and you will see it will snug up. Install the hardware properly and it snugs up to the trim piece and is a very clean fit. As with any aftermarket part, it's not as simple as R&R factory parts. You have to think a little and do a small amount of work. End result is very clean. Also if you are using a glowshift pod then use their gauges. If you want autometer gauges then get a pod from autometer. Don't complain things don't fit when you try combining multiple companies products.

Seems to be decent quality for the price. The construction was good but the fit leaves a little to be desired.I assumed that there would be some issues fitting auto meter gauges to a glow shift pillar pod that’s not unexpected.

I have this gauge pod installed in my 1996 F-150. If you are looking for a perfect fit and factory look, this is not the product for you; it fits OK, but not perfect, and is obviously added on. For my work truck, however, it does the job and provides a place to mount gauges without getting in my way or looking out of place. I installed it using my own self-drilling screws through the existing pillar trim and it looks fine with my gray and black interior. I wouldn't put it in a show truck, but it is a good functional value for the money.

My three Autometer gauges each have a pair of 1" - 1.5" metal studs on the back. The studs bottom out in the pockets of this pod, so I was faced with the choice of drilling holes in the back of each pocket to accomodate each gauge, or making the gauges stand out about an inch from the pocket. I chose the latter option and wrapped each gauge in some black electrical tape to make things look cleaner.Otherwise, it fits my 94 F-250 just fine, and as a bonus, it stopped the rattling of my existing a-pillar plastic, which was driving me crazy.

It fit's great and look's great.

This product is perfect as far as line-of-sight...If you're 6' 3" Tall. The top gauge is a bit hard to read otherwise and it would be nice if all the pods were tilted a little further down. Other than that, fits reasonably well for a mass-produced part and the price was good.