Description
- please do not use this on a Arduino board!!!! it is not working with it!!
- 2.5W 3.5W and 5.5W ARE ALL FOCUSABLE
- Frequency: <15khz, PWM/TTL: 0-5V , Please add a fan when engraving or cutting, in case smoke damage its lens.
- When you connect laser to your controller board, please pay attention to the pin positions of 12v+ GND- and PWM/TTL, red wire=12V+, black wire=GND-. Yello wire=PWM+, white wire=PWM-(3-4pin wire). So Red Wire must be connected to the 12v+ pin on your controller board’s interface, Black Wire Must be connected to the GND- pin and Yellow Wire must be connected to the PWM/TTL pin, if you use 3-4pin wire, White wire should be connected to the PWM- pin.
- if your controller board’s laser interface pins are in different position, please change the wires position to make it match the positions of + - PWM of your interface. If the wires connected wrong, it will damage the diode and the driver board.
- ›See more product details
Size:3.5W
Technical Parameters: Laser wavelength: 445nm-450nm blue laser Spot type: dotted (adjustable) Output power: 2.5W, 3.5W, 5.5W Size: 2.5W(33*70mm) , 3.5W(33*70mm) 5.5W(40*70mm) Drive mode: external ACC constant current drive Cooling method: forced air cooling Operating voltage: 12V DC Control interface: 2 * 2.54 (TTL control switch, PWM control power) Shell material: aluminum, surface anodized Collimator lens: optical glass coating PACKING LIST: LASER*1 3PIN CABLE*1 3PIN TO 4PIN CABLE*1 SAFETY GLASSES*1
