High Mount LED 3rd Brake Light Center Light for 1995-2015 Toyota Tacoma (Black Cover Smoke Lens)

Simple install and looks great. My oem brake light seal failed and was leaking water into my cab and this item fixed that

Looks great and easy to install

They are not super bright but without a doubt bright enough and do the job. They do look very clean when on the truck and I did NOT get the feeling of a cheap product when I had it in my hand. Super easy install and exactly what i paid for is exactly what I got. If your thinking about it just do it you’ll be glad you did

2009 Tacoma Access Cab - install was very easy after prying up the old light and cleaning the surfaces. The sticky backing insert is nice but could be a couple millimeters thicker to handle the contours better. This light does not flush mount, meaning it is not contoured to match the curves of the truck. Leaves a small gap where water could conceivably get in. I sealed the gaps with silicone. All said, light brightness is satisfactory and the look is very nice.

I have a 2006 Tacoma and the best part is you don’t need to remove the headliner for this upgrade. You’ll need to remove the 2 screws holding the OEM lenses on. Then you’ll need a plastic trim remover to pry the old light assembly off because it’s taped on. Then once you clean all of the old sticky stuff off, you can tape the new foam gasket to the back of the new light, attach the harness and then screw the new light in using the longer screws that come with the light. Took me about 30 minutes total and I took my time. No body work or silicone needed. Also, no electrical work needed. The OEM wiring plugs right into the new light.

Install professionally, use electrical greese

fixed the old part with this new one. Nice replacement

This looks real good on my 2014 Tacoma. But when you're installing it, make sure you apply the foam to the light itself and then put it on the truck. Otherwise it might not align properly and you'll have foam sticking up where it shouldn't be.