J**S
Would not spray
When I went to use it there was no propellent in the can and it would not spray.
J**R
Does not work, unless bed is heated when applying
After many failed prints using this stuff (not sticky AT ALL) when following the directions on the can, I tried applying it to the bed with the bed fully heated (110deg, I'm printing with PETG). This actually worked wonderfully, the only reason I gave it more than 1 star... Does not work nearly as well as WolfBite, that stuff is magical.
E**C
Works great but needs help for complicated prints
It works. Obvisiously the number 1 thing to 3d printing is to have your bed leveled correctly or this will not work. There was a more complicated print to where I needed to use supports and the supports were not sticking very well, so I had to use some Elmer's Glue to help keep it on the bed.The one star missing is because on the product it states you need to use acetone to remove it. I wanted to get the Elmer's Glue off but keep the Stickybeds on so I used water. Unfortantely just water will also remove the Stickybeds.
E**.
This is NOT odorless
Disappointed in the adhesion strength. Building on clear glass can give great finish, where "standars" adhesives can leave their marks. This adhesive solves most of that as long as you apply several -5-6 layers. It is then that quite a strong -chemical smelling- odor emits.
C**.
The 3 layers must be applied according to the instructions, so it works well.
The 3 layers must be applied according to the instructions, so it works well.
Y**E
Was not sticky
Wasn’t sticky. After ready the bottle it said you needed many layers- time waste, I’ll use a glue stick.
Trustpilot
2 months ago
2 weeks ago
