Bed Sticker for QIDI TECH X-MAX 3D Printer: 2 pcs kit

I destroyed the one that came with the printer because I could not get 3d prints off bed for they stuck too much to surface. I now use 50/50 water/alcohol mixture and spray on for 10 seconds, then 3d parts pop right off. These are great, easy to use and clean up after use. Hopefully will not need to buy again, because I am getting smarter on how all this 3d printing stuff works :)

When the PC build surface of my Qidi Tech X-Max started wearing out I bought these as direct replacements. They are the exact same as what came with the printer. A little expensive in my opinion, thus the 4 stars, but otherwise they work great.

Great product which replaced the one I destroyed learning on. I have gained knowledge and also I have a couple of new sheets to experiment with. A previous owner suggested a comment/helpful tip of placing a small amount of 50/50 water alcohol mixture on the plate to remove stuck prints have enhanced my 3D printing efforts. It also helped me remove a hard to move piece. Happy printing.

Great quality, fits and aligns perfect. Used in my Qidi X-max.

DIY a better version with a laminator, 3m 467mp, and 3mm polycarb sheeting. This de-laminates too easily.

Good adhesion for prints and easy to remove parts. The one I broke was entirely my fault, I printed on the wrong side...

Great product, would buy it again.

Thankfully it can bend a little and wasn't damaged in transit.