calimaero® HWG 5" Outdoor Dryer Vent Cover – Stainless Steel Exhaust Fan Cover for Walls – Weatherproof Wall Vent Hood for Basements & Metal Pipes – High Airflow Exterior Vent Cover

The gasket is 1/4" thick while the cavity is 1/2" deep. Odd until you realize the gasket has a cavity designed for inserting the metal frame (not set inside the cavity). Its a bit tricky to get it to stay in place - once you do, suggest leaving it overnight so it'll stretch a bit. I used gorilla glue in the cavity, then held the rubber in place with 4 large binder clamps until it adhered to the metal edge. Installing over a flat surface it fine, but over bricks, planks, etc., the provided gasket worthless - just get some 5/8" thick rubber and fill that cavity or silicone it in place.The vent itself is rugged and it fits VERY snugly inside a 4" duct. If it's too snug to enter the duct (a problem I had), flatten the 3 holding clips a little. A ring of silicone sealant inside the duct prior to inserting the vent provides a better exhaust seal and eases installation. I also filled teh 1/2" cavity with silicone to firmly seal the vent to the duct. This will force the exhaust air through the port, avoiding moisture build-up against the wall.

Great replacement for the plastic vent, which was falling apart after only a few years.Easy to install, even though getting the rubber gasket in place took a bit of an effort.

I measured my old one that I wanted to replace and being a silly old lady, I measured the length and width of the cover - 6”. After it arrived and I saw how huge it was, I realized I was supposed to measure the round pipe it that it’s meant to cover. Ok, so I sent it back to Amazon and sent my son to a very popular home improvement store to get one there. He came home with the right size, but it was the flimsiest and cheapest piece of crap vent, it has sharp edges on it and was little more than aluminum foil. So brought that back and re-ordered this one in the 4” size from Amazon. Arrived today. Quality is unbelievable. Sturdy, no sharp edges, finished off nicely, heavy, solid, made exceptionally well and will last another 50 years. And, it was less expensive than the flimsy one! Five stars.

Perfect fit on my 4" duct outlet. Looks good from the outside, but the flap doesn't appear to be strong enough to stay closed on it's own, leading to potential pest and moisture intrusion.

I know this was designed for metal pipe only, but I cut the tabs off and used with extra heavy duty flex pipe that I also got from Amazon, talk about a perfect fit. The quality and construction of this dryer vent is the best. I didn't have to do and modification to the house to try to adapt it to fit, is was as if they have made it exactly for my house. PERFECT FIT. This replace the original vent hood that was installed when the house was built in 1986 and they nailed to to the house (we have 5/8 hardi plank (with 10 penny galvanized nails.I highly recommend this dryer vent hood and would certainly buy it again.Best quality material and craftsmanship.Just buy it. B

The vent is well made and works perfectly. It was easy to replace the old vent with this one.

This stainless dryer vent replaced an old plastic unit. The screw holes were in the same place, so it only took about five minutes to install. The flapper valve opens fully with the dryer on and closes fully with the dryer off. The gasket and cushion make the operation silent. The best feature is the cover, which directs the flow down, keeping the lint from blowing on my car, which is parked beside the wall with the vent.

Very nice quality to replace my old plastic one.